I am attempting to constrain the input DMZ port to SecureBindings Contains One Port 443, but am getting an error when I press OK that states: "Cannot change conformance checking to Document. Make sure the ConformanceLevel in XmlReaderSettings is set to Auto for wrapping scenarios."

What does this mean?

I will follow up on your issue. I would like to ask you to provide me with more information about the problem.

1) What version of VS and what edition are you using (i.e. Team Suite, Team Edition for Architects, etc).

2) Do you use one of our demos/samples or you have your own solution?

3) How and where do you restrict the port? I.e. what settings/constrains you use on LDD, on the zone, etc.

1. I am using the trial edition of Team Suite.

2. I was using "Walkthrough: Creating a Security Zone Part 1: To only allow inbound zone traffic over https on Port 443 only".

3. I selected the Internet inbound zone endpoint Settings and Constraints/User Defined/Website/SecureBindings/Operator Contains One Port=443.

Hello
I cannot repro your issue. I followed the walkthrough Creating a Security Zone Part 1 and did the 10 steps "To only allow inbound zone traffic over https on Port 443 only" and it worked just fine for me.

In my zone endpoint settings I can see that secureBindings is check, the operator shows Contains One, and the value shows IpAddress='',Port='443'

If I check the ComplexSetting Collection Editor for the Value I see that I have one Member under the Members list. Member 0 shows IpAddress='',Port='443'

To test this I just created a new ldd and placed a zone endpoint on it and then followed the steps in the walk through for how to only allow inbound zone traffic over port 443.

Thanks
Brian [MSFT]
Microsoft Developer Support
This posting is provided "AS IS" with no warranties, and confers no rights.

Hello
I cannot repro your issue. I followed the walkthrough Creating a Security Zone Part 1 and did the 10 steps "To only allow inbound zone traffic over https on Port 443 only" and it worked just fine for me.

In my zone endpoint settings I can see that secureBindings is check, the operator shows Contains One, and the value shows IpAddress='',Port='443'

If I check the ComplexSetting Collection Editor for the Value I see that I have one Member under the Members list. Member 0 shows IpAddress='',Port='443'

To test this I just created a new ldd and placed a zone endpoint on it and then followed the steps in the walk through for how to only allow inbound zone traffic over port 443.

Thanks
Brian [MSFT]
Microsoft Developer Support
This posting is provided "AS IS" with no warranties, and confers no rights.